ZyXEL Communications ZyWALL USG 100 Series - Configure the Policy Route; How to Use Active-Passive Device HA

Chapter 7 Tutorials
ZyWALL USG 100/200 Series User’s Guide
177
7.14.2 Configure the Policy Route
Now you need to configure a policy route that has the ZyWALL use the range of
public IP addresses as the source address for WAN to LAN traffic.
Click Configuration > Network > Routing > Add.
Although adding a description is optional, it is recommended. This example uses
LAN-to-WAN-Range.
Specifying a Source Address is also optional although recommended. This
example uses LAN_SUBNET1.
Set the Source Network Address Translation to Public-IPs and click OK.
Figure 143 Configuring the Policy Route
7.15 How to Use Active-Passive Device HA
Here is an example of using device HA (High Availability) to backup ZyWALL A (the
master) with ZyWALL B. ZyWALL B automatically takes over all of A’s functions if
A fails or loses its lan1 or wan1 connection.