Chapter 7 Tutorials
ZyWALL USG 100/200 Series User’s Guide
121
4 Enable the interface and add it to a zone. It is highly recommended that you set
the Zone to WAN to apply your WAN zone security settings to this 3G connection.
Leaving Zone set to none has the ZyWALL not apply any security settings to the
3G connection. Enter the PIN Code provided by the cellular 3G service provider
(0000 in this example).
Figure 66 Configuration > Network > Interface > Cellular > Edit
5 Go to the Dashboard. The Interface Status Summary section should contain a
“cellular” entry. When its connection status is Connected you can use the 3G
connection to access the Internet.
Figure 67 Status
To Next Page
Loading...
