ZyXEL Communications ZyWALL USG 100 Series - Page 149

Chapter 7 Tutorials
ZyWALL USG 100/200 Series User’s Guide
149
1 Click Configuration > Object > AAA Server > RADIUS. Double-click the
radius entry. Configure the RADIUS server’s address authentication port (1812 if
you were not told otherwise), key, and click Apply.
Figure 103 Configuration > Object > AAA Server > RADIUS > Add
2 Click Configuration > Object > Auth. method. Double-click the default entry.
Click the Add icon. Select group radius because the ZyWALL should use the
specified RADIUS server for authentication. Click OK.
Figure 104 Configuration > Object > Auth. method > Add
3 Click Configuration > Auth. Policy. In the Authentication Policy Summary
section, click the Add icon.
4 Set up a default policy that forces every user to log in to the ZyWALL before the
ZyWALL routes traffic for them. Select Enable. Set the Authentication field to
required, and make sure Force User Authentication is selected. Keep the rest
of the default settings, and click OK.