ZyXEL Communications ZyWALL USG 100 Series - Page 180

Chapter 7 Tutorials
ZyWALL USG 100/200 Series User’s Guide
180
3 Set the Device Role to Master. This example focuses on the connection from the
LAN (lan1) to the Internet through the wan1 interface, so select the lan1 and
wan1 interfaces and click Activate. Enter a Synchronization Password
(“mySyncPassword” in this example) and click Apply.
Figure 147 Configuration > Device HA > Active-Passive Mode: Master ZyWALL
Example
4 Click the General tab. Turn on device HA and click Apply.
Figure 148 Configuration > Device HA > General: Master ZyWALL Example