Chapter 9 Dashboard
ZyWALL USG 100/200 Series User’s Guide
227
Status This field displays the current status of each interface. The possible
values depend on what type of interface it is.
For Ethernet interfaces:
Inactive - The Ethernet interface is disabled.
Down - The Ethernet interface does not have any physical ports
associated with it or the Ethernet interface is enabled but not connected.
Speed / Duplex - The Ethernet interface is enabled and connected.
This field displays the port speed and duplex setting (Full or Half).
For cellular (3G) interfaces, see Section 10.10 on page 254 for the status
that can appear.
For the auxiliary interface:
Inactive - The auxiliary interface is disabled.
Connected - The auxiliary interface is enabled and connected.
Disconnected - The auxiliary interface is not connected.
HA Status This field displays the status of the interface in the virtual router.
Active - This interface is the master interface in the virtual router.
Stand-By - This interface is a backup interface in the virtual router.
Fault - This VRRP group is not functioning in the virtual router right now.
For example, this might happen if the interface is down.
n/a - Device HA is not active on the interface.
Zone This field displays the zone to which the interface is currently assigned.
IP Address This field displays the current IP address assigned to the interface. If the
IP address is 0.0.0.0, the interface is disabled or did not receive an IP
address and subnet mask via DHCP.
If this interface is a member of an active virtual router, this field displays
the IP address it is currently using. This is either the static IP address of
the interface (if it is the master) or the management IP address (if it is a
backup).
Action Use this field to get or to update the IP address for the interface.
Click Renew to send a new DHCP request to a DHCP server.
Click the Connect icon to have the ZyWALL try to connect a PPPoE/PPTP
interface or the auxiliary interface. If the interface cannot use one of
these ways to get or to update its IP address, this field displays n/a.
Click the Disconnect icon to stop a PPPoE/PPTP or auxiliary interface’s
connection.
Extension Slot This section of the screen displays the status of the extension card slot
and the USB ports.
Slot This field displays the name of each extension slot.
Table 22 Dashboard (continued)
LABEL DESCRIPTION
To Next Page
Loading...
