ZyXEL Communications ZyWALL USG 100 Series - Page 450

Chapter 23 Authentication Policy
ZyWALL USG 100/200 Series User’s Guide
450
Figure 337 Configuration > Auth. Policy > Add
The following table gives an overview of the objects you can configure.
Table 116 Configuration > Auth. Policy > Add
LABEL DESCRIPTION
Create new
Object
Use to configure any new settings objects that you need to use in this
screen.
Enable Policy Select this check box to activate the authentication policy. This field is
available for user-configured policies.
Description Enter a descriptive name of up to 60 printable ASCII characters for the
policy. Spaces are allowed. This field is available for user-configured
policies.
User
Authentication
Policy
Use this section of the screen to determine which traffic requires (or does
not require) the senders to be authenticated in order to be routed.
Source
Address
Select a source address or address group for whom this policy applies.
Select any if the policy is effective for every source. This is any and not
configurable for the default policy.
Destination
Address
Select a destination address or address group for whom this policy
applies. Select any if the policy is effective for every destination. This is
any and not configurable for the default policy.