ZyXEL Communications ZyWALL USG 100 Series - Page 716

Chapter 39 Device HA
ZyWALL USG 100/200 Series User’s Guide
716
4 Connect the ZyWALLs.
Second Option for Connecting the Bridge Interfaces on Two ZyWALLs
Another option is to disable the bridge interfaces, connect the bridge interfaces,
activate device HA, and finally reactivate the bridge interfaces as shown in the
following example.
1 In this case the ZyWALLs are already connected, but the bridge faces have not
been configured yet. Configure a disabled bridge interface on the master ZyWALL
but disable it. Then set the bridge interface as a monitored interface, and activate
device HA.
B
A
Br0 {ge4, ge5}
Br0 {ge4, ge5}
B
A
Br0 {ge4, ge5} Disabled