ZyXEL Communications ZyWALL USG 100 Series - Page 987

Appendix A Log Descriptions
ZyWALL USG 100/200 Series User’s Guide
987
Interface %s is
enabled.
An administrator enabled an interface. %s: interface name.
Interface %s is
disabled.
An administrator disabled an interface. %s: interface name.
%s MTU > (%s MTU - 8),
%s may not work
correctly.
An administrator configured a PPP interface, PPP interface
MTU > (base interface MTU - 8), PPP interface may not run
correctly because PPP packets will be fragmented by base
interface and the peer will not receive correct PPP packets.
1st %s: PPP interface name, 2nd %s: ethernet interface
name.
(%s MTU - 8) < %s MTU,
%s may not work
correctly.
An administrator configured ethernet, vlan or bridge and this
interface is base interface of PPP interface. PPP interface MTU
> (base interface MTU - 8), PPP interface may not run
correctly because PPP packets will be fragmented by base
interface and peer will not receive correct PPP packets.1st
%s: Ethernet interface name, 2nd %s: PPP interface name.
Interface %s links
down. Default route
will not apply until
interface %s links up.
An administrator set a static gateway in interface but this
interface is link down. At this time the configuration will be
saved but route will not take effect until the link becomes
up.1st %s: interface name, 2nd %s: interface name.
name=%s,status=%s,TxP
kts=%u,
RxPkts=%u,Colli.=%u,T
xB/s=%u,
RxB/s=%u,UpTime=%s
Port statistics log. This log will be sent to the VRPT server.
1st %s: physical port name, 2nd %s: physical port status, 1st
%u: physical port Tx packets, 2nd %u: physical port Rx
packets, 3rd %u: physical port packets collisions, 4th %u:
physical port Tx Bytes/s, 5th %u: physical port Rx Bytes/s,
3rd %s: physical port up time.
name=%s,status=%s,TxP
kts=%u,
RxPkts=%u,Colli.=%u,T
xB/s=%u,
RxB/s=%u
Interface statistics log. This log will be sent to the VRPT
server.
1st %s: interface name, 2nd %s: interface status, 1st %u
variable: interface Tx packets, 2nd %u variable: interface Rx
packets, 3rd %u: interface packets collisions, 4th %u:
interface Tx Bytes/s, 5th %u: interface Rx Bytes/s.
Interface %s start
dailing.
A PPP or aux interface started dialing to a server. %s:
interface name.
Interface %s connect
failed: Connect to
server failed.
A PPTP interface failed to connect to the PPTP server. %s:
interface name.
Interface %s
connection
terminated.
A PPP or AUX connection will terminate. %s: interface name.
Interface %s
connection
terminated: idle
timeout.
An idle PPP or AUX connection timed out.1%s: interface
name.
Interface %s connect
failed: MS-CHAPv2
mutual authentication
failed.
MS-CHAPv2 authentication failed (the server must support
mS-CHAPv2 and verify that the authentication failed, this
does not include cases where the servers does not support
MS-CHAPv2). %s: interface name.
Table 300 Interface Logs (continued)
LOG MESSAGE DESCRIPTION