Pannoramic SCAN II 2.2.0 User’s Guide 5.6.1 Settings
• – Profile behavior settings
◦ Use profile history save – With this function each profile modification is saved in Profile
History from which the different stages can be reloaded.
◦ Save interval – Profile content is automatically saved at the specified time-frames.
◦ Enable setting of focus time – Parameters (Short / Normal / Long) related to focus time
will be enabled on the profile settings panel. Normal is set as default.
• – Prescan settings
Unlike scan settings in Microscope or Planner mode, Prescan toolbar includes the same
settings for pre-scanning but these depend on the hardware / filter settings.
January 24, 2020 - Rev. 2 3DHISTECH Ltd. 117(156)
To Next Page
Loading...
