DHCP Server > General Setup
This page configures the DHCP general settings.
Ignore interface
This parameter sets enables or disables DHCP Server on this interface.
Start
This parameter sets the last digit of the starting IP address values to assign. If the Start value is set to 100,
and assuming default IP address of 192.168.4.1, then the DHCP server will only lease out addresses starting
from 192.168.4.100. The default value is 100.
Limit
This parameter sets the number of addresses the DHCP server can lease out. Continuing from the above
example: if the start address is 192.168.4.100 and the server can lease out 150 (default limit value),
available addresses will be from 192.168.4.100 to 192.168.4.249. The default value is 150.
Lease time
This parameter sets duration of an IP lease. Leased out addresses will expire after the amount of time
specified in this field and the device that was using the lease will have to request a new DHCP lease.
The lease time can be set in hours (h) or minutes (m). The minimal amount of time that can be specified is
2 minutes. The default value is 12h.
To Next Page
Loading...
