148 | Aprisa LTE User Manual
QoS > Policy
This page provides setup of QoS policies which determine the rules that the policy engine follows per egress
interface, deciding which traffic is given priority to the selected egress port.
Policy Name
The defined name of the QoS policy
Egress Interface
This parameter sets the interface or group of interfaces configured at ‘Interfaces/Networking > Logical
Interfaces’ in the selected profile policy rules. For example, LAN, WAN and WAN6 interfaces. Multiple policy
rule can be created, but only a single policy rule can be created per egress interface. Single or multiple
classifiers can be assigned to a policy rule which is related to an egress port.
Default DSCP
This parameter assigns the default DSCP to a packet on an egress port when packet does not match any of
the classifier/s rules associated with selected profile policy rules. i.e. when a packet matches a classifier
rule it will assign to a packet the ‘assigned DSCP’ value (define in the classifier tab) and in the policy profile
the default DSCP will be assigned to a packet if the packet doesn’t match to any of the classifier rules
associated with the selected profile policy rules.
Set * for no change or any valid DSCP value of 0 – 63. See commonly used DSCP table on the ‘ingress DSCP
description.
Classifier(s)
This parameter sets the classifier/s rule/s with the selected profile policy rules. Single or multiple classifiers
can be assigned to a policy rule.
To Next Page
Loading...
