218 | Aprisa LTE User Manual
This page displays the device performance monitoring parameters per Ethernet port received (RX) data in
packet and byte level granularity, for Ethernet port high level statistics and troubleshooting.
The results shown are since the page was opened and are updated automatically every 12 seconds.
ETHERNET PORT PARAMETERS
All Ethernet Ports RX
Parameter to show the number of packets received by the customer from the Ethernet
port (including broadcasts, multicasts, unicasts, FCS/CRC error, alignment error,
undersize, jabber, oversize, and fragments)
Parameter to show the number of bytes received by the customer from the Ethernet port
(including broadcasts, multicasts, unicasts, FCS/CRC error, alignment error, undersize,
jabber, oversize, and fragments and excluding IFG framing bytes/bits)
Parameter to show the number of multicast packets received from the customer into the
Ethernet port. Multicast packets are packets that were directed to a multicast address.
Note that this number does not include packets directed to the broadcast address.
Parameter to show the number of errored packets received from the customer into the
Ethernet port caused by CRC errors, FCS Errors, alignment errors, oversized packets,
undersized packets, fragmented packets and jabber packets
Parameter to show the number of oversized packets received from the customer into the
Ethernet port. Oversized packets are longer than 1518 octets excluding framing bits, but
including FCS octets.
Dropped Packets
(congestion)
Parameter to show the number of dropped packets received from the customer into the
Ethernet port due to congestion
Controls
The Reset button clears the current results.
To Next Page
Loading...
