4RF Aprisa LTE - Page 232

232 | Aprisa LTE User Manual
Copy Commands copy <source> <destination> [include-keys]
Source:Destination
Usage
Maximum Access
system:startup-config
Used to transfer the currently saved config to/from external
backup.
A warning is shown if the security level is high, but the
config encryption key is the default or if there is a key
mismatch when importing the config
Admin only
system:eventlog
Copies the Event History Log. Source only
Any (Users below
engineer get log
without security
events)
system:gnsslog
Copies the GNSS Log. Source only
Any
ftp:[url]
Source or destination of ftp. Examples:
Anonymous) ftp://1.2.3.4/test/test.cfg
User/Password) ftp://user:pass@1.2.3.4/xyz/test.log
Any
ftps:[url]
Example: ftps://user:pass@1.2.3.4/xyz/test.log
Any
flash:active-firmware
Destination only. If source is standby firmware, active
partition is swapped.
If the source is available firmware, then it is first installed
to standby before activating.
If the source is remote url, it is loaded to available,
installed to standby then activated.
Admin only
flash:standby-firmware
Can be source only for flash:active-firmware
Admin only
flash:available-firmware
Installs available firmware. When used as destination,
firmware that is not valid will be ignored and an error
reported.
Technician and
above
ltemodem:available-
firmware-1
ltemodem:available-
firmware-2
The LTE router firmware image that is ‘available’ for
installation
Technician and
above
ltemodem:active-firmware
Destination only. Used to install LTE firmware.
Admin only