System Functions and Features as of I7.9
Routing elements 95
syd-0200/3.0 – I7.9 – 11.2009
4. 5. 2 Routing Functions for Incoming Calls
Call distribution is allocated the following incoming routing functions:
• Routing a call to a destination, depending on the position of the allocated
switch group (see "Call destination", page 90).
• Routing a call to an alternative destination if the original destination is either
busy or if the call goes unanswered (see "Alternative Destinations", page 91).
• Restricting the number of calls incoming simultaneously on each call distribu-
tion element (Incoming connections setting) As soon as this limit is exceeded, any
subsequent caller will obtain busy, provided no alternative destination CDE if
busy has been defined.
• Routing a call to data service destinations:
Data service destinations can be configured for each call distribution element
(see "Data services", page 231).
• Routing a call to external remote control or modem:
This destination is normally allocated only once in every system to enable access
to external remote control via a DDI number. (See "Remote controlling features
from outside the system", page 483.)
4. 5. 3 Routing Functions for Outgoing Calls
Outgoing calls via the line keys of a key telephone are routed via the route entered
under KT route (see "Key Telephones", page 122).
To Next Page
Loading...
