ABB ACQ580 Firmware Manual

Introduction to the manual 7
1
Introduction to the manual
Contents of this chapter
The chapter describes applicability, target audience and purpose of this manual. It
also describes the contents of this manual and refers to a list of related manuals for
more information.
Applicability
The manual applies to the ACQ580 pump control program (version 2.03.0.0).
To check the firmware version of the control program in use, see system information
(select Menu - System info - Drive) or parameter 07.05 Firmware version (see page
116) on the control panel.
Safety instructions
Follow all safety instructions.
• Read the complete safety instructions in the Hardware manual of the drive
before you install, commission, or use the drive.
• Read the firmware function-specific warnings and notes before changing
parameter values. These warnings and notes are included in the parameter
descriptions presented in chapter Parameters on page 99.
Target audience
The reader is expected to know the fundamentals of electricity, wiring, electrical
components and electrical schematic symbols.
The manual is written for readers worldwide. Both SI and imperial units are shown.
Special US instructions for installations in the United States are given.

ABB ACQ580 Specifications

General

Protection class	IP21, IP55
Ambient temperature range	-15°C to +50°C
Communication protocols	Modbus RTU
Mounting type	Wall mounted
Control method	vector control
Frequency range	0 Hz to 500 Hz
Protection features	Overcurrent, overvoltage, undervoltage, short circuit