116 Parameters
True 1. 1
Other [bit] Source selection (see Terms and abbreviations on page 100). -
07
07 System info
Drive hardware and firmware information.
All parameters in this group are read-only.
07.03 Drive rating id Type of the drive. (Rating ID in brackets.) -
07.04 Firmware name Firmware identification. -
07.05 Firmware version Version number of the firmware. -
07.06 Loading package
name
Name of the firmware loading package. -
07.07 Loading package
version
Version number of the firmware loading package. -
07.11 Cpu usage Microprocessor load in percent. -
0…100% Microprocessor load. 1 = 1%
07.25 Customization
package name
First five ASCII letters of the name given to the customization
package. The full name is visible under System info on the
control panel or the Drive composer PC tool.
_N/A_ = None.
-
07.26 Customization
package version
Customization package version number. Also visible under
System info on the control panel or the Drive composer PC
tool.
-
07.30 Adaptive program
status
Shows the status of the adaptive program.
See section Adaptive programming (page 43).
-
0000h…FFFFh Adaptive program status. 1 = 1
07.31 AP sequence state Shows the number of the active state of the sequence
program part of the adaptive program (AP). If adaptive
programming is not running, or it does not contain a
sequence program, the parameter is zero.
0...20 1 = 1
No. Name/Value Description Def/FbEq16
Bit Name Description
0 Initialized 1 = Adaptive program initialized
1 Editing 1 = Adaptive program is being edited
2 Edit done 1 = Editing of adaptive program finished
3 Running 1 = Adaptive program running
4…13 Reserved
14 State changing 1 = State change in progress in adaptive programming engine
15 Faulted 1 = Error in adaptive program
To Next Page
Loading...
