ABB ACQ580 - QR Code Generation for Mobile Service Application

Fault tracing 339
For active faults and warnings, see
• Menu - Diagnostics - Active faults
• Menu - Diagnostics - Active warnings
• parameters in group 04 Warnings and faults (page 107).
For previously occurred faults and warnings, see
• Menu - Diagnostics - Fault & event log
• parameters in group 04 Warnings and faults (page 107).
The event log can also be accessed (and reset) using the Drive composer PC tool.
See Drive composer PC tool user’s manual (3AUA0000094606 [English]).
QR code generation for mobile service application
A QR code (or a series of QR codes) can be generated by the drive for display on the
control panel. The QR code contains drive identification data, information on the
latest events, and values of status and counter parameters. The code can be read
with a mobile device containing the ABB service application, which then sends the
data to ABB for analysis. For more information on the application, contact your local
ABB service representative.
To generate the QR code, select Menu - System info - QR code.
Note: If a control panel which does not support QR code generation (version older
than v.6.4x) is used, the QR code menu entry will disappear totally and will not be
available any longer either with control panels supporting the QR code generation.