ABB ACQ580 - Page 20

16 Start-up, control with I/O and ID run
Change the units shown on the panel if needed.
• Go to the edit view of a selected row by
pressing .
• Scroll the view with and .
Go to the next view by pressing (Next).
To give the drive a name that will be shown at the
top, press .
If you do not want to change the default name
(ACQ580), continue by pressing (Next).
For information on editing text, see ACQ580
firmware manual (3AXD50000035867 [English]).
Hint: Name the drive, for example, Pump 1.
Refer to the motor or pump nameplate for the following nominal value settings of the motor.
Enter the values exactly
as shown on the motor or pump nameplate.
Example of a nameplate of an induction (asynchronous) motor:
Check that the motor data is correct. Values are
predefined on the basis of the drive size but you
should verify that they correspond to the motor.
Start with the motor type.Go to the edit view of a
selected row by pressing .
• Scroll the view with and .
Motor nominal cosΦ and nominal torque are
optional.
Press (Next) to continue.
M2AA 200 MLA 4
1475
1475
1470
1470
1475
1770
32.5
56
34
59
54
59
0.83
0.83
0.83
0.83
0.83
0.83
3GAA 202 001 - ADA
180
IEC 34-1
6210/C36312/C3
Cat. no
35
30
30
30
30
30
50
50
50
50
50
60
690 Y
400 D
660 Y
380 D
415 D
440 D
V
Hz kW
r/min A
cos
IA/IN
t
E/s
Ins.cl. F
IP 55
No
IEC 200 M/L 55
3
motor
ABB Motors