￭
To remove a side option
1. Disconnect the control cables from the side option.
2. Open the grounding bar screws.
3. Loosen the locking screw.
Carefully remove the side option from the drive. Note that the option module can
be tightly in position.
￭
Wiring the modules
See the appropriate optional module manual for specific installation and wiring
instructions.
For more information on option modules, see chapter Optional panel bus adapters
and extension modules (page 213).
Reinstalling covers
￭
Reinstalling cover, frames size R0…R2
1. Reinstall the cover.
2. Tighten the retaining screw at the bottom with a screwdriver.
122 Electrical installation
To Next Page
Loading...
