ABB ACS560 - Electrical Installation; Layout; Mechanical Installation

• three additional digital inputs (DI3, DI4 and DI5)
• one analog input (AI1), and
• one digital output (DO1).
The digital output (DO1) is referred as DIO1 in the firmware. This works only in
output mode. You can also use DI4 and DI5 as frequency inputs and DO1 as a
frequency output.
BIO-01 terminal block is removable and uses spring clamps for assembly.
Layout
1
3
2
4
1. Locking tab
2. Fieldbus option module slot
3. Chassis screw
4. I/O connector
￭
Mechanical installation
See section Installing option modules (page 116) .
￭
Electrical installation
See chapter Electrical installation (page 83). If you configure the inputs, set up the
wiring accordingly. The BIO-01 module has removable spring clamp terminals. Use
ferrules on the multistranded cables before assembly.
Sample wiring with the ABB standard macro
214 Optional panel bus adapters and extension modules