Electrical installation
Contents of this chapter
The chapter describes how to check the insulation of the assembly and the
compatibility with IT (ungrounded) and corner-grounded TN systems. It then shows
how to connect the power and control cables, install optional modules and connect
a PC.
Warnings
WARNING!
Obey the instructions in chapter Safety instructions. If you ignore them,
injury or death, or damage to the equipment can occur.
Make sure that the drive is disconnected from the input power during
installation. If the drive is already connected to the input power, wait for
5 minutes after disconnecting the input power.
Required tools
To perform the electrical installation, you need the following tools:
• wire stripper
• screwdriver and/or wrench with a set of suitable bits.
6
Electrical installation 83
To Next Page
Loading...
