ABB ACS560 - Start-Up; Technical Data

Do not chain an external 24 V DC power supply to several drives. Each drive must
be powered by a single 24 V DC power supply, or a separate 24 V DC output of one
auxiliary power source.
24VDC (+)
GND (-)
+24V
DGND
BAPO-01
1
2
3
4
5
External power supply1
Drive2
+24 V internal3
Main power supply4
+5 V internal5
￭
Start-up
To configure the BAPO-01 module:
1. Power up the drive.
2. Set the parameter 95.04 Control board supply to 1 (External 24V) .
￭
Technical data
Voltage and current rating for the auxiliary power supply: +24 V DC ±10%, max.
1000 mA (including internal fan load).
Power loss: Power losses with maximum load 4 W.
224 Optional panel bus adapters and extension modules