ABB ACS560 - Electrical Installation; Mechanical Installation; Start-Up

L1 L2 L3
1
2
3
4
5
6
13
14
3
4
1
2
K1
Θ
OFF
ON
L1 L2 L3
1
ACS560
10 +24V
x DIx
ACS560
￭
Mechanical installation
All brake resistors must be installed outside the drive. Follow the resistor
manufacturer’s instructions.
￭
Electrical installation
Checking the insulation of the assembly
Follow the instructions given in section Resistor braking, frames R0…R3 (page 181).
Connection diagram
See section Connection diagram (page 90).
Connection procedure
See section Connection procedure: frames R0…R2 (page 91).
Connect the thermal switch of the brake resistor as described in section Protecting
the system against thermal overload (page 186).
￭
Start-up
Note: Protective oil on the brake resistors will burn off when the brake resistor is
used for the first time. Make sure that the airflow is sufficient.
Set the following parameters:
Resistor braking 187