symbol of the frame (R0…R8). The frame is marked on the type designation label
attached to the drive, see section Type designation label (page 46).
Quick installation and commissioning flowchart
SeeTask
Type designation la-
bel (page 46)
Identify the frame of your drive: R0…R8.
Planning the electrical in-
stallation (page 67)
Plan the installation: select the cables, etc.
Technical data (page 139)
Check the ambient conditions, ratings and required cooling air
flow.
Mechanical installation:
Unpacking and examining
delivery, frames
R0…R2 (page 55), Unpack-
ing and examining deliv-
ery, frames
R3...R4 (page 56), Unpack-
ing and examining deliv-
ery, frames R5 (page 57),
Unpacking and examining
delivery, frames
R6…R8 (page 59).
Unpack and check the drive.
Operation principle and
hardware description:
Type designation la-
bel (page 46)
Electrical installation:
Checking the compatibil-
ity with IT (ungrounded)
and corner-grounded TN
systems (page 85)
If the drive will be connected to an IT (ungrounded) system,
check that the internal EMC filter and ground-to-phase varistor
are not connected. If the drive will be connected to a corner-
grounded TN system, check that the internal EMC filter is not
connected.
Mechanical installa-
tion (page 51)
Install the drive on a wall.
24 Introduction to the manual
To Next Page
Loading...
