Mechanical installation 49
Installing the drive vertically, frame size R3...R4
1. Mark the hole locations with the mounting template included in the package. Do
not leave the mounting template behind the drive. The drive dimensions and hole
locations are also shown in the drawings, see chapter Dimension drawings on
page 149.
2. Drill the mounting holes.
3. Start the screws or bolts into the mounting holes.
2
3
R3 R4
mm in mm in
a 160 6.30 160 6.30
b 473 18.62 619 24.37
Weight kg lb kg lb
14.86 32.77 23.0 50.72
1
R4R3
inmminmm
6.301606.30160a
24.3761918.62473b
lbkglbkgWeight
41.8919.032.8414.9
￭
Installing the drive vertically, frames R5…R8
1. Mark the punch positions for the six mounting holes with the mounting
template included in the package. Do not leave the mounting template under
the drive.
The drive dimensions and hole locations are also shown in the drawings, see
chapter Dimension drawings (page 171).
Note: You can use only two screws instead of four to attach the lower part of
the drive
Mechanical installation 63
To Next Page
Loading...
