2. Tighten the two retaining screws with a screwdriver.
Connecting a PC
To connect a PC to the drive, there are two alternatives:
• Use an ACS-AP-I/S assistant control panel as a converter with a USB Mini-B
type cable.
1. Lift the USB connector cover from bottom upwards.
2. Put the USB cable Mini-B plug in the control panel USB connector.
3. Put the USB cable A-plug in the USB connector of the PC (3a). The panel
displays text "USB connected" (3b).
106 Electrical installation
Connecting a PC
To be able to connect a PC to the drive, you need a control panel
Connect a PC to the drive with a USB data cable (USB Type A <-> USB Type Mini-B)
as follows:
1. Lift the USB connector cover from bottom upwards.
2. Put the USB cable Mini-B plug in the control panel USB connector.
3. Put the USB cable A-plug in the USB connector of the PC (3a). The panel
displays text “USB connected” (3b).
Note: Panel keys cannot be used when a USB data cable is connected to the panel.
For information on using the Drive composer PC tool, see Drive composer PC tool
user's manual (3AUA0000094606 [English]).
1
3b
2
3a
106 Electrical installation
Connecting a PC
To be able to connect a PC to the drive, you need a control panel
Connect a PC to the drive with a USB data cable (USB Type A <-> USB Type Mini-B)
as follows:
1. Lift the USB connector cover from bottom upwards.
2. Put the USB cable Mini-B plug in the control panel USB connector.
3. Put the USB cable A-plug in the USB connector of the PC (3a). The panel
displays text “USB connected” (3b).
Note: Panel keys cannot be used when a USB data cable is connected to the panel.
For information on using the Drive composer PC tool, see Drive composer PC tool
user's manual (3AUA0000094606 [English]).
1
3b
2
3a
106 Electrical installation
Connecting a PC
To be able to connect a PC to the drive, you need a control panel
Connect a PC to the drive with a USB data cable (USB Type A <-> USB Type Mini-B)
as follows:
1. Lift the USB connector cover from bottom upwards.
2. Put the USB cable Mini-B plug in the control panel USB connector.
3. Put the USB cable A-plug in the USB connector of the PC (3a). The panel
displays text “USB connected” (3b).
Note: Panel keys cannot be used when a USB data cable is connected to the panel.
For information on using the Drive composer PC tool, see Drive composer PC tool
user's manual (3AUA0000094606 [English]).
1
3b
2
3a
124 Electrical installation
To Next Page
Loading...
