ABB ACS560 - How to control the drive through the I;O interface

DescriptionTerm/
Abbrevi-
ation
Optional I/O extension module. Can be installed to the drive together with
a fieldbus adapter module.
BIO-01
Conducts the surplus energy from the intermediate circuit of the drive to the
brake resistor when necessary. The chopper operates when the DC link voltage
exceeds a certain maximum limit. The voltage rise is typically caused by de-
celeration (braking) of a high inertia motor.
Brake chop-
per
Dissipates the drive surplus braking energy conducted by the brake chopper
to heat
Brake resist-
or
Optional relay output extension moduleBREL
DC circuit betweenDC link
Energy storage which stabilizes the intermediate circuit DC voltageDC link capa-
citors
Optional mounting platform for door mounting of control panelDPMP
Mounting platform for control panel (flush mounting)DPMP-01
Mounting platform for control panel (surface mounting)DPMP-02,
DPMP-03
Embedded fieldbusEFB
Fieldbus adapterFBA
Optional CANopen® adapter moduleFCAN
Optional ControlNet™ adapter moduleFCNA-01
Optional EtherCAT® adapter moduleFECA-01
Optional Ethernet adapter module for EtherNet/IP™, Modbus TCP and
PROFINET IO protocols
FENA-01
Optional Ethernet adapter module for EtherNet/IP™, Modbus TCP and
PROFINET IO protocols
FENA-11
Optional Ethernet adapter module for EtherNet/IP™, Modbus TCP and
PROFINET IO protocols, 2-port
FENA-21
Optional PROFIBUS DP® adapter moduleFPBA-01
Physical size of the drive or power moduleFrame,
frame size
Insulated gate bipolar transistorIGBT
DC circuit between rectifier and inverterIntermedi-
ate circuit
26 Introduction to the manual