52 Settings, I/O and diagnostics on the control panel
Supervision You can select three signals to be supervised. If a
signal is outside predefined limits a fault or warning
is generated. For complete settings, see group 32
Supervision on page 248.
32.01 Supervision
status
32.05 Supervision 1
function
32.06 Supervision 1
action
32.07 Supervision 1
signal
32.09 Supervision 1 low
32.10 Supervision 1
high
32.11 Supervision 1
hysteresis
…
32.25 Supervision 3
function
32.26 Supervision 3
action
32.27 Supervision 3
signal
32.29 Supervision 3 low
32.30 Supervision 3
high
32.31 Supervision 3
hysteresis
Stall protection The drive can detect a motor stall and
automatically fault or show a warning message.
Stall condition is detected when:
• current is high (above certain % of motor
nominal current), and
• output frequency (scalar control) or motor speed
(vector control) is below a certain limit, and
• the conditions above have been true for a certain
minimum duration.
31.24 Stall function
31.25 Stall current limit
31.26 Stall speed limit
31.27 Stall frequency
limit
31.28 Stall time
Timed functions s using the drive with timed functions. For complete
settings, see group 34 Timed functions on page
255.
34.100 Timed function 1
34.101 Timed function 2
34.102 Timed function 3
34.11 Timer 1
configuration
34.12 Timer 1 start time
34.13 Timer 1 duration
…
34.44 Timer 12
configuration
34.45 Timer 12 start
time
34.46 Timer 12 duration
34.111 Boost time
activation source
34.112 Boost time
duration
Menu item Description Corresponding
parameter
ACS580 FW.book Page 52 Wednesday, September 21, 2016 9:48 PM
To Next Page
Loading...
