EasyManua.ls Logo

ABB ACS580 - Standard DIO, FI, FO

ABB ACS580
462 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
164 Parameters
10.99 RO/DIO control
word
Storage parameter for controlling the relay outputs eg.
through the embedded fieldbus interface. To control the relay
outputs (RO) of the drive, send a control word with the bit
assignments shown below as Modbus I/O data. Set the target
selection parameter of that particular data (58.10158.114)
to RO/DIO control word. In the source selection parameter of
the desired output, select the appropriate bit of this word.
0000h
0000h…FFFFh RO
/DIO
control word. 1 = 1
10.101 RO1 toggle counter Displays the number of times relay output RO1 has changed
states.
-
0…4294967000 State change count. 1 = 1
10.102 RO2 toggle counter Displays the number of times relay output RO2 has changed
states.
-
0…4294967000 State change count. 1 = 1
10.103 RO3 toggle counter Displays the number of times relay output RO3 has changed
states.
-
0…4294967000 State change count. 1 = 1
11
11 Standard DIO, FI, FO
Configuration of the frequency input.
11.21 DI5 configuration (Only visible with firmware ASCD2 and ASCD4)
Selects how digital input 5 is used.
Digital input
Digital input DI5 is used as a digital input. 0
Frequency input DI5 is used as a frequency input. 1
11.25 DI6 configuration (Only visible with firmware ASCL2 and ASCL4)
Selects how digital input 6 is used.
Digital input
Digital input DI6 is used as a digital input. 0
Frequency input DI6 is used as a frequency input. 1
11.38 Freq in 1 actual
value
Displays the value of frequency input 1 (via DI6 when it is
used as a frequency input) before scaling. See parameter
11.42 Freq in 1 min.
This parameter is read-only.
-
0 16000 Hz Unscaled value of frequency input 1. 1 = 1 Hz
No. Name/Value Description Def/FbEq16
Bit Name Description
0 RO1 Source bits for relay outputs RO1…RO3. See parameters 10.24,
10.27 and 10.30
.
1RO2
2RO3
3 RO4 Source bits for relay outputs RO4…RO5 with a CHDI-01 or CMOD-01
extension module. See parameters 15.07 and.15.10.
4RO5
5 Reserved
6 DIO1 Source bit for digital outputs DO1 with a CMOD-01 extension module.
See parameter 15.23.
7…15 Reserved
ACS580 FW.book Page 164 Wednesday, September 21, 2016 9:48 PM

Table of Contents

Other manuals for ABB ACS580

Related product manuals