212 Parameters
22.75 Motor
potentiometer ramp
time
Defines the change rate of the motor potentiometer. This
parameter specifies the time required for the motor
potentiometer to change from minimum (22.76) to maximum
(22.77). The same change rate applies in both directions.
40.0 s
0.0…3600.0 s Motor potentiometer change time. 10 = 1 s
22.76 Motor
potentiometer min
value
Defines the minimum value of the motor potentiometer.
Note: If vector control mode is used, value of this parameter
must be changed.
-50.00
-32768.00…
32767.00
Motor potentiometer minimum. 1 = 1
22.77 Motor
potentiometer max
value
Defines the maximum value of the motor potentiometer.
Note: If vector control mode is used, value of this parameter
must be changed.
50.00
-32768.00…
32767.00
Motor potentiometer maximum. 1 = 1
22.80 Motor
potentiometer ref
act
The output of the motor potentiometer function. (The motor
potentiometer is configured using parameters 22.71…22.74.)
This parameter is read-only.
-
-32768.00…
32767.00
Value of motor potentiometer. 1 = 1
22.86 Speed reference
act 6
Displays the value of the speed reference (Ext1 or Ext2) that
has been selected by 19.11 Ext1/Ext2 selection. See diagram
at 22.11 Ext1 speed ref1 or the control chain diagram on page
442.
This parameter is read-only.
-
-30000.00…
30000.00 rpm
Speed reference after additive 2. See par.
46.01
22.87 Speed reference
act 7
Displays the value of speed reference before application of
critical speeds. See the control chain diagram on page 445.
The value is received from 22.86 Speed reference act 6
unless overridden by
• any constant speed
• a jogging reference
• network control reference
• control panel reference
• safe speed reference.
This parameter is read-only.
-
-30000.00…
30000.00 rpm
Speed reference before application of critical speeds. See par.
46.01
23
23 Speed reference
ramp
Speed reference ramp settings (programming of the
acceleration and deceleration rates for the drive).
See the control chain diagram on page 446.
23.01 Speed ref ramp
input
Displays the used speed reference (in rpm) before it enters
the ramping and shaping functions. See the control chain
diagram on page 446.
This parameter is read-only.
-
-30000.00…
30000.00 rpm
Speed reference before ramping and shaping. See par.
46.01
No. Name/Value Description Def/FbEq16
ACS580 FW.book Page 212 Wednesday, September 21, 2016 9:48 PM
To Next Page
Loading...
