Installing the fan carriage of an inverter module
(If the inverter module was removed completely instead of only the fan carriage,
proceed to section Installing an inverter module (page 207)).
The installation of the fan carriage is the removal procedure in reverse. See section
Removing the fan carriage of an inverter module (page 125).
Installing an inverter module
Refer to section Installing an inverter module (page 207).
Connecting the motor cables (units with common motor
terminal cubicle or sine output filter)
￭
Output busbars
If the drive is equipped with option +H359, the motor cables connect to a common
motor terminal cubicle. Similarly, if the drive is equipped with option +E206 (sine
output filter), the motor cables connect to the output busbars in the sine filter cubicle.
The location and dimensions of the busbars are visible in the dimensional drawings
delivered with the drive.
￭
Connection diagram
Inverter unit cubicle Common motor terminal or
sine filter cubicle
The recommended cable types are given in the technical data.
￭
Procedure
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
1. Do the steps in section Electrical safety precautions (page 21) before you start
the work.
2. Open the door of the cubicle and remove the shrouding.
3. Lead the cables into the cubicle. Make the 360° grounding arrangement at the
cable entry as shown.
130 Electrical installation
To Next Page
Loading...
