• drive cabinet line-up
• optional modules (if ordered) installed onto the control unit(s) at the factory
• appropriate drive and optional module manuals
• delivery documents.
Make sure that there are no signs of damage. Before attempting installation and
operation, see the information on the type designation labels of the drive to verify
that the delivery is of the correct type.
Moving and unpacking the drive
Move the drive in its original packaging to the installation site as shown below to avoid
damaging the cabinet surfaces and door devices. When you are using a pallet truck,
check its load capacity before you move the drive.
The drive cabinet is to be moved in the upright position.
The center of gravity of the cabinet is high. Be therefore careful when moving the unit.
Avoid tilting.
￭
Moving the drive in its packaging
Lifting the crate with a forklift
WARNING!
Obey the local laws and regulations applicable to lifting, such as requirements
for planning the lifting, for capacity and condition of lifting equipment, and
for training of personnel.
Mechanical installation 69
To Next Page
Loading...
