WARNING!
Do not stand or walk on the cabinet roof. Make sure that nothing presses
against the roof, side or back plates or door. Do not store anything on the roof
while the drive is in operation.
￭
Attaching the cabinet (non-marine units)
Alternative 1 – Clamping
1. Insert the clamps (included) into the twin slots along the front and rear edges of
the cabinet frame body and fasten them to the floor with a bolt. The recommended
maximum distance between the clamps in the front edge is 800 mm (31.5”).
2. If floor mounting at the back is not possible, attach the top of the cabinet to the
wall with L-brackets (not included in the delivery) bolted to the lifting eye/bar
holes, and suitable hardware.
Attaching top to wallClamping bottom to floor
Mechanical installation 75
To Next Page
Loading...
