￭
Connectivity for wired remote monitoring (option +K496)
This option provides a gateway to connect the drive to ABB Ability™ via a local Ethernet
network. Includes NETA-21 remote monitoring tool and FMBT-21 Modbus/TCP adapter
module.
See the appropriate manual for more information.
Code
(English)
Manual
3AUA0000096939NETA-21 remote monitoring tool user’s manual
3AUA0000096881NETA-21 remote monitoring tool installation and start-up guide
3AXD50000158607FMBT-21 Modbus/TCP adapter module user’s manual
3AXD50000158560FMBT-21 Modbus/TCP adapter module quick installation and start-up guide
￭
Connectivity for wireless remote monitoring (option +K497)
This option provides a gateway to connect the drive to ABB Ability™ via a wireless 4G
network. Includes NETA-21 remote monitoring tool, FMBT-21 Modbus/TCP adapter
module and modem.
See the appropriate manual for more information.
Code
(English)
Manual
3AUA0000096939NETA-21 remote monitoring tool user’s manual
3AUA0000096881NETA-21 remote monitoring tool installation and start-up guide
3AXD50000158607FMBT-21 Modbus/TCP adapter module user’s manual
3AXD50000158560FMBT-21 Modbus/TCP adapter module quick installation and start-up guide
3AXD50000837939InRouter 615-S commissioning guide
￭
Additional terminal block X504 (option +L504)
The standard terminal blocks of the drive control unit are wired to the additional
terminal block at the factory for customer control wiring. The terminals are spring
loaded.
Note: The optional modules inserted in the slots of the control unit are not wired to
the additional terminal block. The customer must connect the optional module control
wires directly to the modules.
Cables accepted by the terminals of the additional I/O terminal block:
• solid wire 0.2 … 2.5 mm
2
(24…12 AWG)
• stranded wire with ferrule 0.25 … 2.5 mm
2
(24…12 AWG)
• stranded wire without ferrule 0.2 … 2.5 mm
2
(24…12 AWG).
￭
Thermal protection with PTC relays (options +L505, +2L505, +L513,
+2L513, +L536, +L537)
PTC thermistor relay options are used for overtemperature supervision of motors
equipped with PTC sensors. When the motor temperature rises to the thermistor
wake-up level, the resistance of the sensor increases sharply. The relay detects the
change and indicates motor overtemperature through its contacts.
Operation principle and hardware description 57
To Next Page
Loading...
