Lay the cabinet on the rollers and move it carefully
until close to its final location.
Remove the rollers by lifting the unit with a crane,
forklift, pallet truck or jack.
Moving the cabinet on its back
WARNING!
Do not transport a drive with a sine filter (option +E206) on its back. It will
damage the filter.
Support the cabinet from below alongside the cubicle seams.
Cabinet back panel1
Support2
Moving the cabinet to its final position
Move the cabinet into its final position with a slate
bar (spud bar). Put a piece of wood between the
edge of the cabinet and the bar to protect the
cabinet frame.
Mechanical installation 73
To Next Page
Loading...
