Use of component designations
Some device names in the manual include the component designation in brackets (for
example, [Q20]). This will help you to identify the components in the circuit diagrams
of the drive.
Quick installation, commissioning and operation flowchart
SeeTask
Guidelines for planning the electrical in-
stallation (page 89)
Plan the electrical installation and acquire the accessories
needed (cables, fuses, etc.).
Technical data (page 223)
Check the ratings, required cooling air flow, input power
connection, compatibility of the motor, motor connection,
and other technical data.
Ambient conditions (page 239)
Check the installation site.
Mechanical installation (page 67)
Unpack and check the drive (only intact units may be started
up).
Make sure that all necessary optional modules and equipment
are present and correct.
Install the drive mechanically.
Routing the cables (page 105)
Route the cables.
Compatibility check - IT (ungrounded)
earthing system (page 116)
If the drive is about to be connected to an IT (ungrounded)
system, check that the drive is not equipped with EMC filter
+E202.
Electrical installation (page 115)
Connect the power cables.
Connect the control cables.
Installation checklist (page 171)
Check the installation.
If the drive has been non-operational for
more than one year, reform the DC link
capacitors. See Converter module capa-
citor reforming instructions
(3BFE64059629 [English]).
Start-up (page 173)
Start the drive up.
ACS880 quick start-up guide, firmware
manual
Operate the drive: start, stop, speed control etc.
28 Introduction to the manual
To Next Page
Loading...
