Use of fasteners in cable lug connections
Use the bolts, nuts and washers delivered with the drive. Install all the fasteners in the
correct order. See the figure below. Tighten the cable lug to the torque specified for
the connection.
Cable lug on one side of the busbar
Cable lugs on both sides of the busbar
Cable lug4Bolt1
Spring washer5Plain washer2
Nut6Busbar3
Connecting a PC
WARNING!
Do not connect the PC directly to the control panel connector of the control
unit. It can cause damage.
A PC (with, for example, the Drive composer PC tool) can be connected as follows:
1. To connect a control panel to the unit, either
• insert the control panel into the panel holder or platform, or
• use an Ethernet (eg, Cat 5e) networking cable.
2. Remove the USB connector cover on the front of the control panel.
3. Connect an USB cable (Type A to Type Mini-B) between the USB connector on the
control panel (3a) and a free USB port on the PC (3b).
4. The panel will display an indication whenever the connection is active.
5. See the documentation of the PC tool for setup instructions.
Electrical installation 135
To Next Page
Loading...
