Electrical installation 111
9
10
￭
Installing an inverter module
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
Before you replace an inverter module with a new one, make sure that the connector
of the auxiliary power supply cable in the cabinet is compatible with the counterpart
in the module (X50). Black connector is compatible only with the black counterpart,
and gray connector only with the gray counterpart. If the connectors are not
compatible, replace the connector in the new module. Use the connector from the old
module, or order suitable connector from ABB. Refer to Connector replacement guide,
auxiliary power supply for ACS880-104 R8i, ACS880-304 D8T and D7T
(3AXD50001060015 [English]) or Connector replacement guide, auxiliary power supply
Maintenance 207
To Next Page
Loading...
