ABB ACS880-104

150 Parameters
43 Brake chopper Settings for the internal brake chopper. 355
44 Mechanical brake control Configuration of mechanical brake control. 357
45 Energy efficiency Settings for the energy saving calculators. 361
46 Monitoring/scaling settings Speed supervision settings; actual signal filtering; general scaling
settings.
364
47 Data storage Data storage parameters that can be written to and read from
using other parameters’ source and target settings.
368
49 Panel port communication Communication settings for the control panel port on the drive. 371
50 Fieldbus adapter (FBA) Fieldbus communication configuration. 373
51 FBA A settings Fieldbus adapter A configuration. 381
52 FBA A data in Selection of data to be transferred from drive to fieldbus controller
through fieldbus adapter A.
382
53 FBA A data out Selection of data to be transferred from fieldbus controller to drive
through fieldbus adapter A.
383
54 FBA B settings Fieldbus adapter B configuration. 383
55 FBA B data in Selection of data to be transferred from drive to fieldbus controller
through fieldbus adapter B.
384
56 FBA B data out Selection of data to be transferred from fieldbus controller to drive
through fieldbus adapter B.
385
58 Embedded fieldbus Configuration of the embedded fieldbus (EFB) interface. 385
60 DDCS communication DDCS communication configuration. 393
61 D2D and DDCS transmit
data
Defines the data sent to the DDCS link. 406
62 D2D and DDCS receive
data
Mapping of data received through the DDCS link. 410
74 ESP control Enables ESP function parameters. 418
75 ESP reference setup Controls frequency/speed reference settings of a drive. 421
76 ESP automatic control Enables ESP automatic control. 426
79 Load protection Enables/Disables Underload and Overload protection functions. 429
80 Voltage control Monitors voltage in the motor. 437
81 Pump cleaning Enables pump cleaning function. 440
85 Q-H pump curves Estimates flowrate of pump curves in ESP application. 446
90 Feedback selection Motor and load feedback configuration. 451
91 Encoder module settings Configuration of encoder interface modules. 460
92 Encoder 1 configuration Settings for encoder 1. 463
93 Encoder 2 configuration Settings for encoder 2. 470
94 LSU control Control of the supply unit of the drive, such as DC voltage and
reactive power reference.
470
95 HW configuration Various hardware-related settings. 473
96 System
Language selection; access levels; macro selection; parameter
save and restore; control unit reboot; user parameter sets; unit
selection; data logger triggering; parameter checksum calculation;
user lock.
479
97 Motor control Motor model settings. 489
Group Contents Page