ABB ACS880-104

550 Additional parameter data
(Parameters 62.151…62.203 only visible when supply unit control activated by 95.20)
62.151 INU-LSU data set 11 data 1 sel Real List --
62.152 INU-LSU data set 11 data 2 sel Real List --
62.153 INU-LSU data set 11 data 3 sel Real List --
62.201 INU-LSU data set 11 data 1
value
Real 0…65535 - -
62.202 INU-LSU data set 11 data 2
value
Real 0…65535 - -
62.203 INU-LSU data set 11 data 3
value
Real 0…65535 - -
74 ESP control
74.01 ESP control word PB 0000h…FFFFh - 1 = 1
74.20 Restart delay enable List ---
74.21 Restart delay time Real 0.0...30000.0 min 10 = 1min
74.30 Speed observer enable List ---
74.31 Restart speed limit low Real -600.00...0.00 Hz 100 = 1Hz
74.32 Restart speed limit high Real 0.00...600.00 Hz 100 = 1Hz
74.33 Observer speed check time Real 0.0...32000.0 s 10 = 1s
74.39 Measurement delay Real 3.0...32000.0 s 10 = 1s
74.50 Time control enable List ---
74.51 On time Real 0.0...90000.0 min 10 = 1min
74.52 Off time Real 0.0...90000.0 min 10 = 1min
74.79 Fly-start speed check List ---
74.80 Observer speed measured Real 0.00...600.00 Hz 100 = 1min
74.99 ESP start/stop sw PB 0000h…FFFFh - 1 = 1
75 ESP reference setup
75.11 Pump speed ref source - - - -
75.12 Fixed speed ref Real -600.00...600.00 Hz 100 = 1Hz
75.13 Speed reference scaler Real 0...30000 - 1 = 1
75.15 Starting speed Real 0.00...600.00 Hz 100 = 1
75.18 Minimum production speed Real 0.00...600.00 Hz 100 = 1
75.19 Maximum production speed Real 0.00...600.00 Hz 100 = 1
75.21 Acceleration time Real 0.0...1800.0 s 10 = 1s
75.22 Deceleration time Real 0.0...1800.0 s 10 = 1s
75.23 Ramp switch speed Real 0.00...600.00 Hz 100 = 1Hz
75.24 Acceleration time 2 Real 0.0...1800.0 s 10 = 1s
75.25 Deceleration time 2 Real 0.0...1800.0 s 10 = 1s
75.40 Acceleration assistance
enable
List ---
75.42 Acceleration assistance speed
limit
Real 0.0...100.0 s 10 = 1s
75.46 Acceleration assistance
current
Real 0.0...300.0 % 10 = 1%
No. Name Type Range Unit FbEq32