ABB ACS880-104

304 Parameters
Selected 1. 1
DI1 Digital input DI1 (10.02 DI delayed status, bit 0). 2
DI2 Digital input DI2 (10.02 DI delayed status, bit 1). 3
DI3 Digital input DI3 (10.02 DI delayed status, bit 2). 4
DI4 Digital input DI4 (10.02 DI delayed status, bit 3). 5
DI5 Digital input DI5 (10.02 DI delayed status, bit 4). 6
DI6 Digital input DI6 (10.02 DI delayed status, bit 5). 7
DIO1 Digital input/output DIO1 (11.02 DIO delayed status, bit 0). 10
DIO2 Digital input/output DIO2 (11.02 DIO delayed status, bit 1). 11
FBA A MCW bit 7 Control word bit 7 received through fieldbus interface A. 30
EFB MCW bit 7 Control word bit 7 received through the embedded fieldbus
interface.
32
Other [bit] Source selection (see Terms and abbreviations on page 148). -
31.12 Autoreset selection Selects faults that are automatically reset. The parameter is a
16-bit word with each bit corresponding to a fault type.
Whenever a bit is set to 1, the corresponding fault is
automatically reset.
The number and interval of reset attempts are defined by
parameters 31.14…31.16.
WARNING! Before you activate the function, make
sure that no dangerous situations can occur. The
function resets the drive automatically and continues
operation after a fault.
Notes:
• The autoreset function is only available in external control;
see section Local control vs. external control (page 24).
• Faults related to the Safe torque off (STO) function cannot
be automatically reset.
The bits of this binary number correspond to the following
faults:
0000h
0000h…FFFFh Automatic reset configuration word. 1 = 1
No. Name/Value Description Def/FbEq16
Bit Fault
0 Overcurrent
1Overvoltage
2 Undervoltage
3 AI supervision fault
4 Supply unit
5…7 Reserved
8 Application fault 1 (defined in the application program)
9 Application fault 2 (defined in the application program)
10 Selectable fault (see parameter 31.13 User selectable fault)
11 External fault 1 (from source selected by parameter 31.01 External event 1 source)
12 External fault 2 (from source selected by parameter 31.03 External event 2 source)
13 External fault 3 (from source selected by parameter 31.05 External event 3 source)
14 External fault 4 (from source selected by parameter 31.07 External event 4 source)
15 External fault 5 (from source selected by parameter 31.09 External event 5 source)