NoteAction
Screw: M6x65 12.9 Gleitmo
603+Geomet 500 (12 pcs)
Secure with screws.6
Tightening torque: 11.5 Nm
xx2000001694
xx2000001698
Mark the screws aligned with the oil openings.7
Putting the base on its side
NoteAction
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
1
Put the base on its side for easily refitting the
motor and base cover.
2
Refitting the axis-1 motor
NoteAction
Check that:
• all assembly surfaces are clean and without
damages
• the motor is clean and undamaged.
1
Continues on next page
274 Product manual - CRB 1300
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.4.1 Replacing the base
Continued
To Next Page
Loading...
