ABB CRB 1300 - Page 395

NoteAction
xx2000001729
Support the weight of the extender unit (only for
CRB 1300-7/1.4 and ), tubular and tilt unit, and
remove the screws.
2
xx2000001728
Valid for CRB 1300-11/0.9 and CRB 1300-10/1.15
Separate the tubular from the housing.
3
xx2000001727
Valid for CRB 1300-7/1.4 and
Separate the extender unit from the housing.
4
Removing the axis-4 mechanical stop slider
NoteAction
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
1
xx2000001732
Access the axis-4 mechanical stop slider from the
housing.
Put it aside for later refitting.
2
Continues on next page
Product manual - CRB 1300 395
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.5.2 Replacing the housing and extender unit
Continued