Securing the cable package in the housing
NoteAction
Screw: M4x8 12.9 Lafre
2C2B/FC6.9 (4 pcs)
Refit the axis-4 cable protector.1
Tightening torque: 2.6 Nm
xx2000001546
Reconnecting the axis-4 motor connectors
NoteAction
xx2000001545
Insert the male header of the motor connectors
to the connector plate.
1
xx2000001544
Reconnect the connectors.
• FB4
• MP4
Tip
See the number markings on the connectors for
help to find the corresponding connector.
2
xx2000001543
Route and secure the cabling with a cable strap.
Note
The motor cablings have another strap fixed. Pay
attention to the location where the new strap to
be fixed, see the figure as a guidance.
CAUTION
Correct cable routing is highly important.
If the cables are routed and secured incorrectly
the cables can be damaged.
3
Continues on next page
Product manual - CRB 1300 413
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.5.2 Replacing the housing and extender unit
Continued
To Next Page
Loading...
