NoteAction
xx2000001539
Disconnect the air hoses.3
xx2200001001
For robots with Ethernet cabling
Access the connector from the process hub and
disconnect the connector.
• J1.C2
Tip
Take photos of the connector and cable position
before disconnecting them, to have as a reference
when reconnecting.
4
Tip
The connector clip has to be pressed (1) and
pushed forward (2) to separate the J2.C2 (for
Ethernet cabling).
xx1800002943
Removing the lamp unit
Notice that the procedure is valid only when the lamp unit needs a replacement.
NoteAction
xx2200001002
Remove the lamp unit cover.1
Continues on next page
428 Product manual - CRB 1300
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.5.3 Replacing the tubular and tilt unit
Continued
To Next Page
Loading...
