Refitting the tubular
NoteAction
O-ring on tubular: 3HAC061327-
018
For robots with protection class IP67 (option
3350-670)
1
xx2000002519
Check the O-ring.
Replace if damaged.
Screw: M4x25 12.9 Lafre
2C2B/FC6.9 (12 pcs)
Refit the tubular and tilt unit to the extender unit.2
Tightening torque: 3.8 Nm
xx2000001739
xx2000001742
Make sure that the notches on the extender unit
and tubular are aligned.
3
Refitting the axis-6 motor
NoteAction
Check that:
• all assembly surfaces are clean and without
damages
• the motor is clean and undamaged.
1
Continues on next page
468 Product manual - CRB 1300
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.5.3 Replacing the tubular and tilt unit
Continued
To Next Page
Loading...
