ABB CRB 1300 - Page 502

NoteAction
xx2000001627
Access the screws and washers securing the axis-
2 motor from the swing support.
7
xx2000001626
Remove the screws and washers.8
xx2000001628
Carefully lift out the motor.9
Refitting the motor
Use these procedures to refit the axis-2 motor.
Refitting the axis-2 motor
NoteAction
Axis-2 motor for CRB 1300-7/1.4:
3HAC073078-001
CAUTION
Do not mix the axis-2 motor used for CRB 1300-
7/1.4 and .
Always carefully check the part number attached
to the motor and the robot type, and refit with the
right one.
1
Check that:
• all assembly surfaces are clean and without
damages
• the motor is clean and undamaged.
2
Continues on next page
502 Product manual - CRB 1300
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.6.2 Replacing the axis-2 motor
Continued