ABB CRB 1300 - Page 647

NoteAction
xx2000001678
Make sure that :
• the block on the mechanical stop flange is
towards the upper side (process hub side).
• the notches on the extender unit/tubular
and the mechanical stop flange are aligned.
2
Valid for CRB 1300-11/0.9 and
CRB 1300-10/1.15
xx2000001718
Valid for CRB 1300-7/1.4 and
xx2000001677
Check the radial sealing on the housing
Note
This procedure is valid for robots with:
NoteAction
xx2000002483
Check the radial sealing on the housing.
Replace if damaged, as described below.
1
Continues on next page
Product manual - CRB 1300 647
3HAC083111-001 Revision: B
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.7.4 Replacing the axis-4 gearbox
Continued