￭ Configuring the Siemens SIMATIC Fail-safe S7 PLC
WARNING!
This safety program is only an example which you can use only for trial purposes
to get the system up and running.
This example shows how to configure the communication between the Siemens SIMATIC
Fail-safe S7 PLC and the FSPS-21 module using SIMATIC Manager Step 7 (version
V5.5+SP4) and S7 Distributed Safety Programming (version V5.4+SP5).
For detailed configuration instructions, see the documentation of the safety PLC (S7
Distributed Safety - configuring and programming, Programming and Operating Manual,
07/2013, A5E00109537-05).
Before you start, make sure that you have downloaded the FSPS-21 GSD file from the ABB
Document library. See section .
1. Start SIMATIC Manager and open/create a SIMATIC project.
2. Add the necessary objects to the project. In this example, a SIMATIC 300 Station and
an Industrial Ethernet object have been added.
3. Open the hardware configuration of the project.
PROFIsafe 149
To Next Page
Loading...
