PROFINET IO – Start-up
Contents of this chapter
This chapter contains:
• information on configuring the drive for operation with the adapter module
• drive-specific instructions on starting up the drive with the adapter module
• examples of configuring the master station for communication with the adapter module.
Warnings
WARNING!
Obey the safety instructions given in this manual and the drive documentation.
Drive configuration
The information in this section applies to all drive types compatible with the FSPS-21 module,
unless otherwise stated.
￭ PROFINET IO connection configuration
After the adapter module has been mechanically and electrically installed, you must prepare
the drive for communication with the module.
The detailed procedure of activating the module for PROFINET IO communication with the
drive depends on the drive type. Normally, you must set the PROFINET parameters to
establish the communication. See the Starting up fieldbus communication for
drives (page 56).
Once communication between the drive and the adapter module has been established,
several configuration parameters are shown to user. These parameters are listed in the
12
PROFINET IO – Start-up 47
To Next Page
Loading...
